How to maintain door and window making machinery in winter?
Winter is coming, the temperature drops, and the window and door making machine may have various problems under low temperature conditions. In order to better use the equipment, we have deliberately sorted out the following precautions to provide you with a winter door and window equipment maintenance cautions for our readers!
First: Milling equipment (double-head saw, end milling, profile milling, angle saw, aluminum wood milling machine, 90 degree cutting saw, etc.)
1. After get off work every day, clean up the aluminum (wood) chips on the equipment, especially the transmission parts and movable parts of the equipment (for example: rails, cylinders, work panels, etc.);
2. Regularly check the screws of each part of the equipment to prevent loosening, leading to accuracy errors and safety accidents.
3. Regularly wipe the transmission shafts of the equipment with relatively diluted lubricating oil (for example: linear guide);
4. The aluminum machine chooses oily cutting fluid, and the water ratio is appropriately reduced;
5. Check the equipment air circuit and solenoid valve body for icing before starting work every day to ensure that the air circuit is unobstructed before using the equipment. In order to avoid freezing in the air path, the air compressor must be waterproofed every day, and the filter element must be replaced.
6. Check whether the power switch is normal and whether the wire is aging every day. If there is any problem, replace it immediately.
7. Handle aluminum profiles, wood, etc. with care to prevent bumps and errors that may cause equipment damage.
8. Equipment that is forbidden to work with gloves, and ensure that working with gloves is strictly prohibited. Do not wear scarves and other similar clothing to prevent safety accidents.
Second: Assembly equipment (, aluminum and wood frame machine, etc.)
1. Clean up the aluminum (wood) chips and sludge accumulated in the area of the equipment platform;
2. Add lubricating oil to each movable part of the countertop;
3. Fill the angle machine hydraulic oil with 32# hydraulic oil as much as possible;
4. Check the equipment air circuit and solenoid valve body for icing before starting work every day to ensure that the air circuit is unobstructed before using the equipment. In order to avoid freezing in the air path, the air compressor must be waterproofed every day, and the filter element must be replaced.
5. Regularly check the screws of each part of the equipment to prevent loosening, resulting in accuracy errors and safety accidents.
6. Check whether the power switch is normal and whether the wire is aging every day. If there is any problem, replace it immediately.
7. Handle aluminum profiles, wood, etc. with care to prevent bumps and errors that may cause equipment damage.
8. Equipment that is forbidden to work with gloves, and ensure that working with gloves is strictly prohibited. Do not wear scarves and other similar clothing to prevent safety accidents.